Appearance
HACCP plan
Also known as
- new HACCP plan
- hazard
- CCP
- critical limit
- monitoring
- record reading
- temperature log
- corrective action
- deviation
- food safety plan
The HACCP plan page holds the hazard analysis and the critical control points of one process, and is where operators record monitoring readings and corrections.
Create a plan
- Open QualityHACCP and select New HACCP plan.
- Under Plan, enter the Code, Name, Product, HACCP team, Review date and Scope.
- Under Hazard analysis, select Add hazard for each: Process step, Type (Biological, Chemical, Physical, Allergen), Description, Severity and Likelihood (1 to 5; Risk is their product), Significant and the Control measure.
- Under Critical control points, select Add CCP for each: Code, Process step, Parameter, Unit, Critical min and/or Critical max, Target, Monitoring method, Frequency, Responsible and the planned Corrective action.
- Select Create plan, then Activate plan (a plan needs at least one CCP). HACCP plan activated appears.
Record a monitoring reading
- Open an Active plan. The banner says Active plan: monitoring is open.
- In Record monitoring, choose the CCP, type the Reading (the Critical limits are shown), check the Logged time and add the Lot and Notes.
- If the reading is Outside critical limits — deviation, enter the Corrective action taken, and tick Raise a critical NCR for this deviation if the product is affected.
- Select Record reading (needs Permission:
quality.haccp.log).
Latest readings shows the last value per CCP; Monitoring log lists every reading with its status (Ok, Deviation, Corrected) and Observed by. For a deviation without a correction, select Record correction, describe it and Save correction.
Change or retire a plan
- Revise plan returns an active plan to draft as the next version, to change hazards or CCPs; activate it again when done.
- Retire ends the plan; no more monitoring is recorded.
